News

Company Information

Industry Information

FAQ

2021-09-26

Industrial hose, rubber hose how to identify the good and bad?

The rubber hose is divided into two kinds of high pressure hose and low pressure hose. The high pressure hose is generally composed of four parts: outer rubber layer, steel wire reinforcement layer, middle rubber layer and inner rubber layer. The inner rubber layer of the hose is in direct contact with the hydraulic oil and is generally made of synthetic rubber. The load-bearing capacity of the hose depends on the reinforcement layer, which is the skeleton of the hose and is usually made of steel wire braiding or winding. Most of the medium and high pressure hoses use steel wire braid as the skeleton, while high pressure and ultra high pressure hoses use steel wire winding skeleton. The outer rubber layer of the hose is generally made of rubber with good wear and corrosion resistance to ensure that the reinforcement layer is not subject to mechanical damage, chemical corrosion and moisture rusting.

Industrial hose, rubber hose how to identify the good and bad?

2021-09-26

What to pay attention to during the installation of steel wire braided hose

Under the premise of guaranteeing the quality of the hose, if it is not used properly, its service life will be greatly shortened. Most of the damage to the hose in use is caused by improper use. The installation of steel wire braided hose is important, if it is not installed properly, it will take time and effort to reinstall. If the installation is not in place, it will affect the service life of the hose, and in serious cases there may be safety hazards.

What to pay attention to during the installation of steel wire braided hose
< 12 > proceed page